Статья помогает покупателям подготовить чертежи, материал, размеры, покрытие и данные для RFQ по металлическим деталям.
Define Where the Functional Length Starts and Ends
Do not assume that total length alone explains the functional requirement. Some shafts seat against a shoulder, some pins stop at a groove, and some replacement parts work only when one end projects a fixed amount after assembly. Buyers should identify which faces contact mating parts and which length actually controls fit.
If one end is more important than the other, mark a datum end on the drawing or sketch. This is especially useful when one side has a chamfer, radius, thread runout, cross hole or retaining feature that changes how the part is measured in production and inspection.
State Whether Chamfers, Radii and Burr Removal Are Included
A common sourcing mistake is to specify a cut length without saying whether the measurement includes edge break, chamfer or rounded ends. On pins and short shafts, a small chamfer can be enough to affect installation depth, cotter alignment or visible projection length after assembly.
If burr control matters, say so directly. Saw cutting, shearing, lathe cutting and secondary facing can all produce different end conditions. The best route depends on the diameter, tolerance, end-face requirement and order quantity, so the drawing should separate length tolerance from end-finish expectation.
Match Tolerance to the Real Assembly Need
Very tight length tolerance is not always the most important control point. For rotating shafts, straightness, runout or shoulder location may matter more than an extremely narrow overall-length window. For locating pins, hole position or working diameter may be more functional than decorative end consistency.
Buyers should tighten length tolerance only where the assembly truly requires it. An over-specified drawing can increase machining, facing and inspection work without improving performance. A clearer RFQ explains which dimensions are critical, which are reference-only and which features must be checked together with the mating part.
Include Packing and Identification for Mixed Sizes
Length-related mistakes often appear after production, not during machining. When a shipment contains several similar shafts or pins with close diameters but different cut lengths, weak carton labeling or mixed bundling can create receiving errors at the buyer's warehouse. If the parts support aftermarket service or line-side replenishment, packing identification should be part of the RFQ.
For quotation review, buyers should send the drawing or sample together with material grade, diameter, functional length, tolerance, end condition, surface treatment, quantity per size and packing request. Shandong Juyi Metal Products Co., Ltd. can review custom shaft and pin requirements according to the actual application and provide an inquiry-based quotation.